A door that drops a little and then climbs back up is usually reacting to a blocked or crooked sensor rather than a worn-out opener. Call the number on this page to be connected with a local garage door company in Pasadena.

Bounces off the floor
A door that touches the slab and then jumps back up makes many owners blame the motor. Often a sensor lost its beam, or the down limit needs a tweak. Tell the company exactly where the door stops and turns around.
Mention how far down it gets, because that detail narrows the search quickly.
A bracket that drifted
The most frequent fault is plain misalignment. Brackets loosen, a stray bike clips one, and settling slabs flex the wall a little over time. The receiver lamp shows whether it still catches the beam. Re-aiming is quick, though the reason it moved deserves a look.
Bumped brackets and flexing garage walls are very common in homes on clay soil.
Salt-laden air near the bay and Gulf eats at sensor terminals and bracket screws, and wind-driven rain can seep into housings, so corrosion is a regular suspect for failing eyes.
Cause and likely work
| Cause | Usual work |
|---|---|
| Crooked eye | Re-aim and test |
| Damaged wire | Splice or re-run |
| Dead sensor | Replace the pair |
Ask for the likely range once the cause is known.
Signs the job is done
The door closes fully, reverses on contact and no lamps blink. Watch one full cycle with the technician. If the fault returns, call the company back and mention exactly when it happens.
Keep the receipt and a note of the date in case it recurs.
Good to know in Pasadena
The 2x4 test is quick: lay the board flat in the door's path and close the door. Under the federal opener rule the door should reverse on contact; if it doesn't, stop using the opener until it's adjusted or replaced.
Many neighborhoods here have an HOA or deed restrictions. If the work changes the door's look, such as a new style, window layout or color, check the approval process before anything is ordered.
If the job grows into widening the opening or reframing the header, check with City of Pasadena permit office before work starts.
If the opener and the lights quit together, call your electric utility's outage line first. The emergency release cord lets you open a balanced door by hand; pull it only with the door closed.
Companies that take calls here usually also work in South Houston, Deer Park and Galena Park.
Nudging an eye back
If one sensor was clearly bumped, you can sometimes ease it until its lamp glows steady. Do not bend brackets or force the housing. After a try or two without success, stop and call rather than crack a lens.
Gentle handling beats force, since lenses crack easily.
Garage Door Sensor Repair questions in Pasadena
Can I wipe the sensors myself?
What if only one sensor lamp is lit?
How can I test that the door still reverses?
Can a storm or power surge damage the eyes?
More garage door services in Pasadena
Garage Door Sensor Repair nearby
Helpful guides
Sources
Last updated: