Garage door repair referrals for Houston & nearby townsCall: (713) 843-7194
(713) 843-7194

Garage door won't close: the usual culprits

garagedoorrepairhoustontx.net

A garage door that stops halfway, bounces back up or does nothing at all is frustrating, and most of the causes are small. This page walks through the checks a homeowner can safely do and the signs that mean it is time for a call.

Need garage door help now?
Call now to be connected with a local garage door company in Houston.
(713) 843-7194

A garage door that stops halfway, bounces back up or does nothing at all is frustrating, and most of the causes are small. This page walks through the checks a homeowner can safely do and the signs that mean it is time for a call.

You press the button, the door starts down, and then it reverses, flickers a light or does not move at all. Before you assume the opener has died, there is a short list of causes that account for a large share of these calls. Some of them take thirty seconds to rule out. Others involve springs and cables, which are not owner jobs. This guide goes from the easiest check to the ones that need a professional.

Start with what the door is telling you

The way a door fails to close points toward the cause. Pay attention to what happens, not only that it happens.

  • The door starts down and then reverses before it touches the floor. This usually points to the safety sensors or the travel settings.
  • The door does not move, and the opener light blinks or the opener clicks. This often means the sensors are blocked or misaligned.
  • The opener runs but the door does not move. This can mean a disconnected door, a stripped gear or a broken spring.
  • The remote does nothing, but the wall button works. That points to the remote, its battery or the receiver.
  • The door closes crookedly, or one side hangs lower than the other. That can be a cable, a spring or an off-track problem.

Check the photo-eye sensors first

Every residential opener sold in the United States must have entrapment protection. Under the federal rule at 16 CFR part 1211, a vertical door must reverse within two seconds of touching an obstruction, and a secondary device such as an external photoelectric sensor must be supplied with the opener or as an accessory. When a photoelectric sensor is triggered while the door is closing, the door must reverse and fully reopen. That is the system doing its job. It also explains why a dirty or bumped sensor can keep the door from closing.

Two small units sit a few inches off the floor on either side of the opening. One sends a beam and the other receives it. If anything interrupts the beam, the opener treats it as an obstruction. Safe owner checks include:

  • Look for a stored item, a bag, a hose, a leaf pile or a toy blocking the beam.
  • Wipe each lens gently with a soft, dry cloth. Spider webs and dust are common in a humid Houston garage.
  • Check that each unit's indicator light is on and steady. A dark or blinking light often means the unit is misaligned or has lost power.
  • Make sure neither sensor was knocked sideways by a bumper, a bicycle or a lawn mower. If one is, nudge it back to point at the other unit and see if the lights settle.
  • In bright low sun at certain times of day, glare can sometimes confuse a sensor. If the problem only happens early or late, that is a clue to mention on the phone.

If the indicator lights stay dark after a gentle realignment, a wire may be loose, pinched or corroded. Do not cut or splice wires yourself. A company handling garage door sensor repair can trace the problem. National figures from HomeGuide list sensor repair at about $85 to $100.

Remote, wall button and lock switch

If the door will not close from the remote but works from the wall, try the simple things first. Replace the battery in the remote. Stand close to the door and try again, since a weak battery or interference can shorten the range. If you have a keypad on the outside, check its battery too.

Many wall buttons have a lock or vacation switch. When it is on, the opener ignores the remotes and may not respond to the button as expected. Look for a small slide or push switch on the wall control. Turning it off is a quick fix that gets mistaken for a dead opener more often than you might think. After a storm, children, guests or a past house sitter may have flipped it without anyone noticing.

If a remote battery and the lock switch do not fix it, the remote may need reprogramming, or the receiver on the opener may be failing. See garage door remote and keypad repair for what is involved.

The 2x4 test and why it matters

If your door is closing but bouncing back up when it should not, or if it is not reversing when it should, the Consumer Product Safety Commission's advice is the most useful reference. It says to put a 2x4 on the floor of the garage in the door's path. If the door does not reverse properly when it hits the board, the opener should be disengaged until it is adjusted, repaired or replaced. This is not a repair. It is a safety check.

Run the test with the door open, the board laid flat and everyone clear of the opening. If the door reverses, the entrapment protection is working. If it does not, do not use the opener, and call a company. A door that closes on a person or a pet is a serious hazard, and CPSC also advises keeping the remote away from children. A related routine is in the five-minute monthly safety check.

Signs the problem is the door, not the opener

Many people blame the opener when the real trouble is in the door's hardware. A few clues:

  • You hear a loud bang and the door will not lift or close. That is the classic broken spring sound, and the first move is in what to do when a garage door spring snaps.
  • One cable hangs loose, or a cable has come off its drum.
  • A roller has popped out of the track, leaving the door crooked or jammed.
  • The door feels heavy when released from the opener and does not hold itself in the middle of its travel.
  • The tracks look bent, dented or pulled away from the wall.

DASMA says spring systems should be repaired only by trained professionals, and that cables should be replaced only by a trained technician because of the high spring tension. If one of those clues matches, do not try to force the door down or hold it in place. Leave the door where it is and make the call.

Weather and Houston-specific causes

The Gulf Coast climate is hard on garage doors in ways that do not come up in drier states. Humid summers and salt air near Galveston Bay mean rust on rollers, hinges and tracks, which can make a door stiff enough that the opener quits or reverses. Heavy rain can push water and silt across a garage floor, and debris can lodge in the track or block a sensor. Expansive clay soil can shift a slab over time, leaving a floor that is no longer level, which can change where the door meets the ground.

If a door stopped closing after a storm or an episode of high water, check for debris in the tracks and at the sensors, and see the page on checking a garage door and opener after high water. After hurricane season winds, a door can also be bent or racked, so a visual check is worth doing before anyone tests the opener.

Things to avoid

  • Do not tape over a sensor or bypass it to make the door close. That disables a safety device the federal rule requires.
  • Do not hold the wall button down to force a door that wants to reverse.
  • Do not touch springs, cables or the brackets that hold them.
  • Do not release the opener and manually push a heavy door if you suspect a spring has failed. The emergency release is for a closed door with springs intact, as the DASMA opener guide describes.
  • Do not stand under a partly open door.

When to call, and what happens next

If the sensor, remote and lock switch checks do not fix the problem, or any sign above points to springs, cables or tracks, it is time to call.

Call now to be connected with a local garage door company in Houston.
(713) 843-7194
When you do, describe what the door does, which checks you tried and whether any lights blink. This is a free referral service, and the company that answers is an independent local garage door company that sets its own prices.

Depending on the cause, one of these pages may match: garage door opener repair for motor, gear and circuit board problems, off-track repair for jammed or crooked doors, or general garage door repair when you are not sure. For reference, Angi's Houston page lists opener motor repair at about $100 to $250 and track repair at about $125 to $300. National HomeGuide figures put opener repair at about $75 to $300. Those are published ranges, not quotes. The guide on what to ask a garage door company before work begins can help you read an offer.

If you are in a nearby town, the service areas page lists the places covered, and the services page shows everything else on offer.

Frequently asked questions

Why does my garage door go down and then back up?
That is usually the entrapment protection working. A blocked or misaligned photo-eye, or a door that meets resistance, makes the opener reverse. Clear the beam, wipe the lenses and check that both sensor lights are steady.
Is it safe to bypass the sensors so the door will close?
No. The sensors are a required safety feature under the federal rule for residential openers. Bypassing them can lead to injury. If they will not work after a simple cleaning and alignment, call a company.
My remote does not work but the wall button does. What now?
Start with the remote battery and the distance from the door. If a lock switch is on at the wall control, turn it off. If neither helps, the remote may need reprogramming or the receiver may be failing.
What does it cost to fix a door that will not close?
It depends on the cause. HomeGuide's national figures list sensor repair at about $85 to $100 and opener repair at about $75 to $300. Angi's Houston page lists track repair at about $125 to $300. Treat these as published ranges, not quotes.
Call now to be connected with a local garage door company in Houston.
(713) 843-7194

Last updated:

☎ Call (713) 843-7194