Garage door repair referrals for Houston & nearby townsCall: (713) 843-7194
(713) 843-7194

After high water: checking a garage door and opener

garagedoorrepairhoustontx.net

Heavy rain and street flooding can push water across a garage floor even when the house stays dry. This guide covers what to look at, what to leave alone and when to bring in a local garage door company.

Need garage door help now?
Call now to be connected with a local garage door company in Houston.
(713) 843-7194

Heavy rain and street flooding can push water across a garage floor even when the house stays dry. This guide covers what to look at, what to leave alone and when to bring in a local garage door company.

Houston gets rain that falls faster than the ground and the storm drains can take it. Harris County Flood Control District says flooding is recurring in the county and that stormwater which cannot drain fast enough can pond and reach the inside of homes. The garage sits lowest on most lots, so it is often the first room to take on water. Once the water goes down, the garage door and opener are easy to forget, and that is a mistake, because a door that looks fine can hide a bent track, a swollen panel or a wet motor.

Start with people and power

Before you think about the door, think about the room. A garage after high water has a wet slab, mud, and often standing water around outlets, the opener's power cord and the wall button wiring. Do not stand in water and touch the opener, its cord, a ceiling outlet or anything plugged in. If the garage still has water on the floor, treat it as unsafe for electrical equipment and wait for it to drain. If you are unsure whether the power to the garage is on, ask an electrician or your electric utility before you go in.

Power loss is also common in a big storm. The National Weather Service Houston/Galveston guide says a major hurricane can mean near-total power loss, with outages lasting from several days to weeks. If your power is out, your opener is not running anyway, and the hand-release question comes up. Our guide on opening a garage door by hand after a storm covers that step by step, including why you should check the springs first.

What water does to each part

A garage door is a set of steel, wood or composite parts that were built for weather, but not for sitting in water. Different parts react in different ways.

The bottom panel and seal

The lowest panel and the rubber seal at the bottom take the most water. Steel panels can start to rust along the lower edge. Wood and wood-composite panels can soak up water, swell and delaminate, and a swollen panel may no longer sit flat or move through the tracks cleanly. The bottom seal can fill with silt, tear or come loose. A seal that has lifted off the panel will leave a gap that lets rain and insects in, and it may be the reason the door seems to stop short when it closes.

Tracks, rollers and hinges

Mud and silt collect in the tracks and on the roller stems. Grit in the track makes the door drag and can wear the rollers fast. Steel hinges and track brackets that sat in water will begin to rust, and rust spreads quickly in Houston's humidity. You can wipe visible mud off the track faces with a damp rag once the door is closed and the power is off. Do not loosen or adjust track brackets, hinges or any fastener on a door that is moving badly. A bent or shifted track is a repair for a trained person.

Springs and cables

The springs and lift cables hold the full weight of the door in balance, which is why they are dangerous. DASMA, the garage door trade association, says spring systems should be repaired only by trained professionals and that cables should be replaced only by a trained technician because of the high spring tension. Water does not make a spring safe to touch. Look at them from the floor. If you see rust flaking off a spring, a gap in a coil, a frayed cable or a cable that has slipped off its drum, keep the door closed and do not run the opener. Our guide on what to do first after a snapped spring explains the steps.

The opener

Most openers hang from the ceiling and the motor head is out of reach of shallow water. The pieces that sit low are the safety sensors, which are mounted a few inches off the floor on each side of the door, and the wall control and its wiring. Sensors that got wet may stop working or may work only some of the time. A door that will not close, or that closes and then goes back up, is often a sensor problem. A door that closes only while you hold the button is usually in sensor-fault mode. Our guide to a garage door that won't close goes through the usual causes.

If water got into the motor head, the circuit board or the wall button, let everything dry fully before anyone applies power. Plugging in a wet opener can ruin it and can create a shock hazard. Because the opener is plugged into an outlet that may also be wet, the safest plan after real flooding is to leave it unplugged until the garage is dry and a person qualified to judge the wiring has looked at it.

A calm look-over once the water is gone

When the floor is dry, the power question is settled and you have good light, do a short visual check from the floor. You are not repairing anything. You are collecting facts that you can pass on to a garage door company.

  1. With the door closed, look along the bottom edge for swelling, rust streaks, cracks or a lifted seal.
  2. Look at both vertical tracks for dents, mud, and gaps between the track and the wall.
  3. Check that each lift cable is tight and sitting in its drum or pulley, without fraying.
  4. Look at the springs for rust, stretched or gapped coils or anything that looks off from last time.
  5. Find the two safety sensors near the floor. Wipe the lenses with a dry cloth and check that each has a steady indicator light once power is back.
  6. Note any smell of mildew, any damp insulation on the inside of the door, and any water marks on the opener.

If everything looks sound and the opener has been dry and powered on safely, you can try a normal open and close with your eyes on the door the whole time. Stop at the first grinding, shaking, crooked movement or odd noise. Then run the check in our five-minute monthly safety check, because floodwater can knock the auto-reverse out of adjustment without any visible sign.

Why the reverse test matters more after water

Federal rules require a residential opener to reverse the door within 2 seconds when it touches an obstruction, and to have a secondary device, such as an external photoelectric sensor, that makes the door reverse and reopen when something blocks its beam. That protection is what keeps a closing door from harming a child, a pet or a car. After a flood, sensors can shift or fail and the force settings can drift. The U.S. Consumer Product Safety Commission advises laying a 2x4 on the floor in the door's path; if the door does not reverse when it hits the board, the opener should be disengaged until it is adjusted, repaired or replaced. Do that test before you trust the door again, and keep the remote away from children while you wait for repairs.

Water that was dirty

Street and bayou flooding is not clean water. Mud, sewage and runoff can sit in the tracks, in the bottom seal and in the insulation panel on an insulated door. Wear gloves and wash up afterward. Insulated doors, which have foam between two skins, can hold moisture inside the panel, and a panel that stays wet can rust from the inside. If a panel stays damp or smells after drying, a company may recommend replacing that section rather than the whole door. For a sense of scale, a Houston cost guide on Angi lists panel replacement at $250 to $500, and national figures from HomeGuide for a single panel run $250 to $800. These are ranges from cost guides, not quotes, and your door's brand, size and style change the price.

What a repair visit may involve

Tell the company what happened when you call: that water reached the garage, how high it got, whether the opener was plugged in at the time and whether the power has been on since. Those details help the person decide what to bring. Typical work after high water includes:

  • Cleaning and checking the tracks and rollers, or replacing rollers that have seized or rusted.
  • Replacing a swollen or rusted bottom section, covered under garage door panel replacement.
  • Putting the door back on its tracks if it jumped during a rough closing, which is off-track repair.
  • Replacing or realigning safety sensors, which is covered by garage door sensor repair.
  • Testing or replacing a wet opener. HomeGuide lists opener repair at $75 to $300 nationally, and the Houston-specific Angi guide puts opener motor repair at $100 to $250.

If the opener is old and water got into it, replacement may make more sense than repair. A national HomeAdvisor guide lists a new opener installed at $218 to $540. Our page on garage door opener installation explains what that job covers. If the whole door took a hit, the repair or replace guide will help you weigh the cost against the age of the door.

Rust that shows up weeks later

Wet steel does not always show damage right away. Springs, hinges and the cable ends can look fine for a week and then bloom with rust, especially in humid air. If your garage took on water, check those parts again a few weeks later and keep an eye out for new squeaks or a door that has become harder to lift by hand. A louder or heavier door can mean a spring is weakening. Our guide to humidity, salt air and rust lists what to watch for on a Gulf Coast door, and a garage door tune-up is the usual way to have the hardware checked and lubricated.

Insurance and records

If the water damage may be part of a claim, take photos of the garage floor, the bottom of the door, the tracks and the opener before cleanup, and keep any written quote. Ask the company to describe the damage and the work in writing. Your homeowner's or flood policy decides what is covered, and this site cannot say. If you are comparing companies, what to ask before work starts lists the questions that make quotes easy to compare.

Getting help

After a widespread flood, many garage door companies are busy, so expect to wait and be ready to describe the problem. Many companies take after-hours calls, and it is fine to ask when you call what their schedule looks like. In the meantime, keep the door closed if you see any sign of spring or cable trouble, keep people and cars clear of its path, and do not run the opener until it has been checked.

Call now to be connected with a local garage door company in Houston.
(713) 843-7194

If you live outside Houston proper, the same advice applies. You can also browse all garage door services to see which job matches what you found.

Frequently asked questions

Can I run my garage door opener after the garage flooded?
Not until the floor is dry and the opener and its outlet have dried out. Wet electrical equipment can fail and can be a shock hazard. Keep it unplugged, check the door by eye from the floor, and run the 2x4 reversal test once it is safe to power up.
Is it safe to open a flooded garage door by hand?
Only with the door closed and only if the springs and cables look intact. DASMA warns that a disengaged door can start to open unexpectedly, and that a door with a broken spring should not be operated. If you see damage, leave it closed.
Will floodwater ruin my garage door?
Not always. Steel doors often survive a short exposure with a cleaning and new hardware. Wood or composite bottom panels, wet insulation and rusty springs are the usual trouble spots. A garage door company can tell you which parts to replace.
Do the safety sensors need to be replaced after a flood?
Not always, but they sit close to the floor and often get wet. If a sensor light is dark or blinking, or the door reverses for no reason, have a company check and realign or replace it.
Call now to be connected with a local garage door company in Houston.
(713) 843-7194

Last updated:

☎ Call (713) 843-7194