Garage door repair referrals for Houston & nearby townsCall: (713) 843-7194
(713) 843-7194

The monthly garage door safety check in five minutes

garagedoorrepairhoustontx.net

A garage door is usually the heaviest moving thing in a house, and the opener is the part that is supposed to stop it when something is in the way. This five-minute check tests those safety features and flags trouble before it turns into an injury or a bigger bill.

Need garage door help now?
Call now to be connected with a local garage door company in Houston.
(713) 843-7194

A garage door is usually the heaviest moving thing in a house, and the opener is the part that is supposed to stop it when something is in the way. This five-minute check tests those safety features and flags trouble before it turns into an injury or a bigger bill.

Most people only think about the garage door when it will not open. The safety side of the door gets far less attention, even though a closing door can weigh well over a hundred pounds. A monthly check takes about five minutes and uses nothing but a piece of wood, a cloth and your eyes. It also fits Houston well: heat, humidity and sudden storms put more wear on a door than a mild climate does, and a monthly routine catches changes early.

What the opener is required to do

Under the federal rule at 16 CFR part 1211, a residential garage door opener must have built-in protection against entrapment. A vertical door must reverse within 2 seconds of contacting an obstruction. A second device, such as an external photoelectric sensor, an edge sensor or an inherent door sensor, must come with the opener or be available as an accessory with it. When the photoelectric sensor is blocked during closing, the door must reverse and fully reopen. In plain terms, your opener has two ways to avoid trapping something, and each one can be tested. If either fails, the opener is not doing its job.

Before you start

Clear the area. Move cars, bikes and storage away from the door's path, and keep children and pets out of the garage while you test. Stand inside the garage, not under the door, and keep the remote or wall button in reach. Grab a flat 2x4 board, a soft cloth and a flashlight. If the door is already acting up, shaking, closing crooked or making a loud bang, skip the test and read the section at the end.

Step one: watch a full cycle

Open and close the door once using the wall button and watch it from a safe spot to the side. A healthy door moves smoothly, at an even speed, with no jerks, no screeching and no sideways wobble. Look at both sides. If one side rises faster, if the door looks crooked or if a cable looks slack, stop and note it. Listen too: a rhythmic scrape can be a dry track or roller, and a sudden bang can mean something let go. A noisy door is not always a danger, and our noisy garage door repair page lists the typical causes, but a change in sound is worth noting.

Step two: the 2x4 reversal test

The U.S. Consumer Product Safety Commission recommends this test. With the door fully open, lay a 2x4 flat on the floor in the center of the door's path. Close the door with the wall button. When the door touches the board, it should reverse and go back up. If it does not reverse, or if it stops and stays down on the board, the opener should be disengaged until it is adjusted, repaired or replaced. Do not rely on it, and do not try to fix it by turning the force screws up. That can make the door push harder on whatever is under it.

The auto-reverse setting is a calibration. It can drift as the door and springs age, after a storm or after a repair. Tests cost nothing and a failure is the cue to call someone, not to experiment. Our page on garage door opener repair explains what a technician typically checks.

Step three: the sensor test

The two small sensors near the floor, one on each side of the door, project an invisible beam across the opening. With the door open, check that each sensor has a steady light. Wipe the lenses with a clean cloth, since dust, spider webs and Houston humidity film can block them. Then start the door closing and pass a broom handle or your foot across the beam low to the floor. The door should reverse right away and go all the way back up. Keep your body out of the door's path while you do this.

If one sensor light is off, blinking or dim, a bumped sensor may be out of line. Look at whether it is pointed straight across at its partner. If a sensor was knocked by a bike or a mower, you can nudge it back toward the other one and see if the light steadies. If that does not work, do not bypass it or tape it. The page on garage door sensor repair describes the job, and national figures from HomeGuide list sensor repair at $85 to $100, with another cost guide listing $110 to $200. Those are national ranges, not quotes.

Step four: check the manual release

Every opener has a release handle, usually a red cord with a knob hanging from the trolley. It lets you detach the door from the opener when the power is out. Look at it once a month to confirm the cord is not tangled, frayed or tied to something. DASMA's opener guide says to start with the door in the closed position when you use the manual disconnect, because a door that is detached while open can drop. It also warns that a disengaged door may unexpectedly begin to open or move, and that a door with a broken spring should not be operated at all.

For that reason, do not test the release with the door open. If you want to know that yours works, pull it only with the door closed and the springs intact, then re-engage it. After a storm or outage, our guide to opening a garage door by hand goes into this in more detail.

Step five: look, do not touch, the springs and cables

Now look up at the hardware. You are checking by eye only. Look at the spring or springs above the door, or along the sides on a door with extension springs. Look for a visible gap in a coil, a spring that looks stretched or a rust bloom. Look at the lift cables on each side. They should be tight and straight, without frayed strands.

DASMA says spring systems are dangerous and should be repaired only by trained professionals, and that cables should be replaced only by a trained technician. Do not adjust, tighten or loosen anything, and do not loosen the bolts on the end brackets. If you see something wrong, keep the door closed and read our guide on a snapped garage door spring. Rust on springs is common near the Gulf, and the humidity and rust guide shows what is normal surface rust and what is a warning.

Step six: the balance feel

This one is only for a door that looks fine in the previous step. With the opener disconnected and the door closed, a properly balanced door can usually be lifted by hand about halfway and will stay there. A door that slams down or rockets up is out of balance, which strains the opener. Because of the risks described above, many people skip this one. If you have any doubt about the springs, the door should stay closed, and a company can run the balance check safely. A garage door tune-up normally includes it.

Keep the remote away from children

The CPSC also says to keep the remote control away from children. A remote left in a car on the seat, or in a toy bin, is a way for a child to start a door they should not be near. Teach children that the garage door is not a toy, and keep the wall button high. If you have a keypad or smart opener, change the code when you hand it out to others. The remote and keypad repair page covers reprogramming, and the smart garage door opener page covers phone controls.

When to stop and call

You should not try to fix a failed safety check yourself. Stop and keep the door closed if any of these happens:

  • The door does not reverse on the 2x4 or when the sensor beam is blocked.
  • The door closes crooked, jumps, or comes off a track.
  • A spring looks broken, a cable looks loose or you heard a loud bang.
  • The opener hums but the door does not move.
  • The door is heavy to lift by hand when the release is pulled.

Some of these mean the door should not be run at all. If you need more than a sensor wipe, a local garage door company can work out whether it is an adjustment, a part or a bigger repair. Costs vary. A Houston cost guide on Angi lists opener motor repair at $100 to $250, and national figures from HomeGuide give $75 to $300 for opener repair. If the opener is old and fails the reverse test, replacement may be the sensible move, and the guide to hiring a garage door company lists what to ask for in a written quote.

Call now to be connected with a local garage door company in Houston.
(713) 843-7194

Make it a habit

Pick a day, such as the first of the month, and tie it to something you already do. Add an extra check at the start of hurricane season and after any storm or flood. Our hurricane season checklist and the guide on checking a door after high water list what to add. If you are in a smaller town, find yours on the service areas page.

Frequently asked questions

How often should I test my garage door opener's safety features?
Once a month is a common routine, and again after storms, floods or any repair. The 2x4 reversal test and the sensor test take only a few minutes.
What if my garage door does not reverse on the 2x4?
Stop using the opener's auto-close and keep the door manual or closed until it is looked at. CPSC advises disengaging the opener until it is adjusted, repaired or replaced. Do not raise the force settings to compensate.
Can I test the safety sensors myself?
Yes. Wipe the lenses, check the lights and pass a broom handle through the beam while the door closes. The door should reverse. If it does not, call a company rather than bypassing the sensor.
Is it safe to check the springs and cables myself?
Only by looking. DASMA says springs and cables should be handled only by trained professionals, so do not touch, tighten or loosen them.
Call now to be connected with a local garage door company in Houston.
(713) 843-7194

Last updated:

☎ Call (713) 843-7194